How to clean before anal sex (and be confident)

July 31, 2024

5 steps on how to do anal shower with Tushtek shower heads. If you don't have a dedicated shower head, you can still follow this tutorial by disassembling the shower head and using the hose.

Before we begin: this article is a variation that we believe improves on this other very popular tutorial, with some differences that will become obvious shortly.

Step 1: Preparation

Remove the shower head with a small rotation and fit the nozzle for intimate cleansing. If you don't have this kind of shower head (you can find it here) you can just use your hose.

Step 2: Adjust the temperature

Very important is the right temperature and pressure of the water. If too cold, it will cause cramps for several hours. If too hot, it will cause pain. The right temperature is around 36-37 degrees.

The pressure during the anal shower must be very low. I therefore recommend that you use a low pressure even while regulating the temperature. The temperature in a shower changes if the pressure changes.

Step 3: Move to the toilet (although many stay in the shower)

I do not recommend releasing in the shower, even though many do, because in addition to causing bad odors and clogging of the drain, it is difficult to get rid of the "waste".

To move from the shower to the toilet, close the valve on the shower head , keeping the faucet open at all times. Now move and sit on the toilet.

Note: Most likely your shower hose is not long enough. You can buy a 3 meter hose, already included in the DOT-Home kit, which is usually enough and not excessive for a shower.

Step 4: Irrigation

Re-open the water flow at very low pressure. Check the temperature again.

Apply light pressure. The water will flow into the rectum on its own. If you can't get the water in, you can use your other hand to apply more pressure to the tip.

For most people, there is no need to apply soap or lubricant, just relax and let the water enter on its own.

Let it flow for a few moments, do not overdo it. A few seconds at low pressure are enough to completely irrigate the rectum.

Step 5: Release (and repeat)

The water will be dirty. Repeat watering-releasing until the water coming out is clean several times in a row.

Pro-tip : To make sure everything is gone, use your finger to "explore".

After washing

After washing, it is a good idea to take a bidet or a shower to eliminate odors and clean the surface. Also remember to flush...

After the cleansing, you can put the work to good use with your partner. Don't wait too long , usually within a few hours a new cleansing may be necessary, especially if you have eaten something in the meantime.

When it doesn't work

Warning, this method does not work if:

Have you had stomach problems in the hours before the cleanse:

This usually means that you probably won't be able to clean. The ideal solution is to postpone the appointment to a better day.

You used water that was too hot or cold:

One of the fundamental conditions is the ideal temperature .

Pro-tip : If you need to, I recommend using a shower temperature sensor to check the water temperature. The sensor is small, requires no electricity, and is easy to install.

You used too much pressure :

The worst thing is to have water stuck inside the intestine. This is caused by too much water pressure, the solution in these cases is to wait an hour or two for the water to find its way out again.

There you go, if we helped you leave a comment below! If we didn't, tell us what went wrong?